Rcrowther at 20:09, 22 April 2017

2017-04-22T20:09:43Z

Rcrowther: filtering installation info

2017-04-22T20:07:06Z

filtering installation info

New page

For those are new here, or need a reminder.

== Where to look ==
{{TOCD}}
The most interesting files are the dictionary files; 'apertium-xxx.xxx.dix' and 'apertium-yyy.yyy.dix' in the respective monodix folders, and 'apertium-xxx-yyy.xxx-yyy.dix' in the bidex folder.

For a fuller list of files and what they do, see the [[Workflow reference]].

=== How to access a pair ===
The configuration of a pair is centred in the bilingual dictionary (see above). This applies to other actions on, or accesses to, the build. For example, if you have a tool, and it is able to find a pair by browsing the system, point it at the bilingual folder. There, the tool will find everything it needs.

=== How to repeatedly compile pairs ===
When the pair directories were set up, the bilingual pair folder was configured from the two monolingual dictionary directories.

Compiling all three folders to make corrections would be tedious. The Apertium build avoids this. The build is gathered in the bilingual folder. Go there ('apertium-xxx-yyy/'), and type this special command,

<pre>
make langs
</pre>

and you will see all three folders compile in the terminal output.

If you have a fast modern computer,

<pre>
make -j3 langs
</pre>

will attempt to compile using three cores.

Folders can be compiled individually, but you will rarely need to do this.

== For beginners: how do I use it? ==
I would say, ignore mention of tools like <code>lt-proc</code>. Ignore the instructions you find on the Wiki, some of them date back a long way, or deal with the tools in detail.

Look at these two pages, [[Modes introduction]] and [[Monodix basics]]. Use modes directly from the commandline, and start doing what you want to do, work on languages.

== ...and for pros: Bash completion ==
You can get tab-completion on mode names (and the '--with-lang' arguments to autogen.sh) by adding 'http://wiki.apertium.org/wiki/Bash_completion'.

[[Category:Installation]]
[[Category:Documentation in English]]

← Older revision		Revision as of 20:09, 22 April 2017
Line 41:		Line 41:

	== ...and for pros: Bash completion ==		== ...and for pros: Bash completion ==
	You can get tab-completion on mode names (and the '--with-lang' arguments to autogen.sh) by adding ~~'http://wiki.apertium.org/wiki/Bash_completion'~~.		You can get tab-completion on mode names (and the '--with-lang' arguments to autogen.sh) by adding [[Bash completion]].

Install How to use a build - Revision history

Rcrowther at 20:09, 22 April 2017

Rcrowther: filtering installation info