Talk:Documentation

From Apertium
Jump to navigation Jump to search

Official documentation (214 pages) has an error on page 12: 2.2. Data Stream without format. Into that text a picture is projected. Muki987 11:07, 9 April 2009 (UTC)


Standard format for README files

A proposal for a standard format for README files in Apertium. This is for a language pair between Language1 and Language2, using the ISO codes code1 and code2. The note about regression tests would be removed if the language pair has none of course.

Language1 and Language2

                            apertium-code1-code2
===============================================================================

This is an Apertium language pair for translating between Language1 and 
Language2. What you can use this language package for:

* Translating between Language1 and Language2
* Morphological analysis of Language1 and Language2
* Part-of-speech tagging of Language1 and Language2

For information on the latter two points, see subheading "For more 
information" below

Requirements
===============================================================================

You will need the following software installed:

* lttoolbox (>= 3.1.2)
* apertium (>= 3.1.1)
* vislcg3 (>= 0.9.7.5129)

If this does not make any sense, we recommend you look at: www.apertium.org

Compiling
===============================================================================

Given the requirements being installed, you should be able to just run:

$ ./configure 
$ make
# make install

You can use ./autogen.sh instead of ./configure you're compiling from
SVN. If you're using a --prefix to ./configure, make sure it's the
same one you used to install apertium itself.

Testing
===============================================================================

If you are in the source directory after running make, the following
commands should work:

$  echo "My hovercraft is full of eels" | apertium -d . code1-code2
My skeertuig is vol palings

$ echo "My skeertuig is vol palings" | apertium -d . code2-code1
My hovercraft is full of eels

After installing somewhere in $PATH, you should be able to do e.g.

$  echo "My hovercraft is full of eels" | apertium code1-code2
My skeertuig is vol palings

The following command runs tests which are on the Apertium wiki page:

$ ./regression-tests.sh 

Files and data
===============================================================================

* apertium-code1-code2.code1.dix        - Monolingual dictionary for Language1
* apertium-code1-code2.code1-code2.dix  - Bilingual dictionary 
* apertium-code1-code2.code2.dix        - Monolingual dictionary for Language2
* code1-code2.prob                      - Tagger model for Language1
* code2-code1.prob                      - Tagger model for Language2

For more information
===============================================================================

* http://wiki.apertium.org/wiki/Installation
* http://wiki.apertium.org/wiki/apertium-code1-code2
* http://wiki.apertium.org/wiki/Using_an_lttoolbox_dictionary

Help and support
===============================================================================

If you need help using this language pair or data, you can contact:

* Mailing list: apertium-stuff@lists.sourceforge.net
* IRC: #apertium on irc.freenode.net